GB
- 25 -
8. Completely empty the container (12). Always
keep the container (12) free of residue and
check it for damage.
9. Use a rag soaked in solvent or water to clean
the outside of the paint spray gun and the
container (12).
10. Unscrew the air cap retaining ring (1) and
remove the air cap (2). Remove the nozzle
(3). Push the
fl
uid needle adapter (B) onto the
fl
uid needle (13). Twist and pull to remove the
fl
uid needle. Clean the air cap retaining ring,
air cap, nozzle and
fl
uid needle with a bristle
brush and solvent or water.
11. Remove the
fi
lter cap (16) to clean the air inlet
fi
lter. Remove the
fi
lter and clean it by blowing
out with air. Replace the
fi
lter and screw the
fi
lter cap onto the gun. Do not operate the gun
without the
fi
lter.
12. Reinsert the
fl
uid needle. Pull the trigger and
insert the nozzle on the
fl
uid needle. While
inserting, ensure that the pins on the sides of
the
fl
uid needle point up/down and not right/
left. Pull the trigger while placing the air cap
on the nozzle and tightly fasten the air cap
with the air cap retaining ring.
13. Ensure that the paint spray gun is completely
dry before storing it.
14. Properly dispose of residual paint and
cleaning agents in accordance with local laws
and regulations. Residual paint and solvents
must be taken to a suitable collection point. If
you are not sure, ask the local council where
the nearest collection point is.
Warning!
Never immerse the paint spray gun in water or
other liquids. The housing may only be cleaned
with a dampened rag.
Note:
If you use 2-component paint, you must
clean the gun immediately. Otherwise the paint
may dry inside the gun, causing an equipment
fault.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a quali
fi
ed electrician.
Danger!
The carbon brushes should not be rep
laced by anyone but a quali
fi
ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
!
www.kwb.eu
welcome@kwb.eu
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council o
ffi
ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
Anl_TC_SY_600_700_SPK9.indb 25
Anl_TC_SY_600_700_SPK9.indb 25
16.07.2018 16:56:23
16.07.2018 16:56:23
