6
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Proper use
The delta grinder/sander is designed for the
sanding/grinding of wood, iron, plastic and similar
materials using the appropriate sanding/grinding
paper.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
3. Technical data
Mains connection
230 Volt ~ 50 Hz
Power input
180 W
Oscillating speed
8000 min
-1
Abrasive paper size
90 x 90 x 90 mm
Protection class
II /
쓑
Weight: 1.2
kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level
72.3 dB(A)
K
pA
uncertainty 3
dB
L
WA
sound power level
83.3 dB(A)
K
WA
uncertainty 3
dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 60745.
Vibration emission value a
h
≤
2.5 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
4. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate are
identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
4.1 Changing the abrasive paper
The sanding/grinding disk comes with a Velcro
fastening system for sanding/grinding paper. This
permits new sanding/grinding paper to be attached
without a clamping device.
Before you attach a new piece of sanding/grinding
paper, knock out any dirt from the Velcro fastener and
clean with a brush or, if necessary, with compressed
Anleitung_BT_DS_180_SPK1:_ 21.01.2008 16:43 Uhr Seite 6
