GB
11
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Figs. 1/2/3)
1. Setting knob for the chip depth
2. Dust
bag
3. Safety
lock-off
4. ON/OFF
switch
5. Rear base plate
6. Belt
cover
7. Chip
ejector
8. Front base plate
9. Changeover switch for chip ejector
10. Power cable
11. Thumb screw for step depth scale
12. Step depth scale
13. Parallel stop
3. Proper use
The hand-held electric plane is designed for planing,
rabating and chamfering pieces of wood.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage:
230 V ~ 50 Hz
Power input:
750 W
Idling speed:
16,500 min
-1
Chip depth:
0-2 mm
Rebate depth:
0-6 mm
Plane width:
82 mm
Protection class:
II /
쏾
Weight:
2.9 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level
87,5 dB(A)
L
WA
sound power level
98,5 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 60745.
Vibration emission value a
h
= 4,189 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Anleitung_BT_PL_750_SPK1:_ 15.09.2008 15:06 Uhr Seite 11
