GB
- 33 -
11. Troubleshooting
Fault
Possible Cause
Remedy
Motor does not start a) Motor terminals disconnected
b) Machine standing in high grass
c) The mower housing is clogged
d) Safety plug is not inserted
e) Battery is not correctly inserted
a) Have it checked by a customer ser-
vice workshop
b) Start motor on shorter grass or al-
ready mowed area; change cutting
height if necessary
c) Clean housing so that the blade
can run freely
d) Insert the safety plug (see 6.)
e) Remove the battery and reinsert
(see 5.)
The drive motor
does not start
a) Motor terminals disconnected
b) Machine standing in high grass
c) The mower housing is clogged
d) Safety plug is not inserted
e) Battery is not correctly inserted
f) Thermal cut-out switch has tripped
a) Have it checked by a customer ser-
vice workshop
b) Start motor on shorter grass or al-
ready mowed area; change cutting
height if necessary
c) Clean housing so that the blade
can run freely
d) Insert the safety plug (see 6.)
e) Remove the battery and reinsert
(see 5.)
f) Let the equipment cool down for at
least 10 minutes
Motor performance
drops
a) Grass too tall or damp
b) The mower housing is clogged
c) Blade badly worn
d) Battery performance decreasing
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
Unclean cuts
a) Blade worn
b) Wrong cutting height
a) Replace or resharpen the blade
b) Correct the cutting depth
Important! In order to secure the engine and the batteries, these are equipped with a thermal
switch, which switches o
ff
when overloaded and automatically switches on again after a coo-
ling phase!
Anl_GE_CM_36_47_S_HW_Li_SPK9.indb 33
Anl_GE_CM_36_47_S_HW_Li_SPK9.indb 33
13.12.2018 11:39:58
13.12.2018 11:39:58
