Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Ensure that you observe the following points in order
to avoid accidents and injuries.
Do not overload your swing arm. Do not continue to
use the swing arm if it is damaged.
Ensure that all bolts are tightly fastened and check
them frequently for your own safety. Ensure that the
cotter pin is properly inserted through the bore holes.
Lifting and carrying persons with the cable winch is
strictly prohibited! Additionally, persons may not loiter
underneath the cable winch/swing arm assembly.
Persons who are not aware of these safety
precautions may not use this product.
All components must be regularly checked for any
kind of deformation or damage.
Observe the maximum permissible load capacity
(see „Technical Data“)!
2. Layout and items supplied (Fig. 1/2)
1
1. Cotter pin Ø 3 x 30
1
2. Hexagon nut M12
1
3. Spring washer Ø 12
1
4. Washer Ø 12
1
5. Hinge pin, large
1
6. Hexagon bolt M 12 x 60
1
7. Pipe collar for support arm
1
8. Cotter pin Ø 3 x 45
1
9. Pipe collar for rectangular boom
10. Support arm
11. Rectangular boom 45 x 45 x 1.8
12. Hexagon bolt M 12 x 70
13. Pads for clamping brackets
14. Hexagon nut M8
15. Spring washer Ø 8
16. Washer Ø 8
17. Extension pipe 40 x 40 x 2.5
18. Hexagon bolt M8 x 15
19. Hinge pin, small
20. Sleeve
3. Proper use
The swing arm is designed to be attached to a cable
winch. For this, the swing arm must be mounted to a
well fastened steel bar with a diameter of 48 mm.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data:
Reach l:
Max. load:
l
1
= 750 mm
m
1
= 600 kg
l
2
= 1,100 mm
m
2
= 300 kg
Swing range: max. 180°
5. Before putting the machine into
operation
The swing arm is designed to take a cable winch.
To mount the swing arm, you need a round steel
bar with a diameter of Ø 48 mm; its wall must be
a minimum of 3 mm thick. Ensure that the anchor
points of the steel bar are able to adequately
support the forces that will be applied to it.
Consult an authorized professional to ensure that
this is properly done.
GB
10
Anleitung_GT_SA_1200_SPK1:_ 09.08.2007 17:44 Uhr Seite 10
