Layout of the control panel
1. Temperature
Press the
∆
button to raise the temperature and the
button to lower the temperature.
2. Sleep function
If the SLEEP button is pressed in cooling mode, the
temperature will be raised 1°C above the set
temperature after 1 hour.
3. Fan
The fan speed can be regulated with the HI and LO
buttons.
4. Timer
The timer can be set for a range of 1 to 12 hours. If
the timer is not set at all, the appliance will switch off
automatically after 24 hours.
5. Display window
The display shows: the room temperature
the time setting
the temperature setting
6. Swing
If you press the SWING button, the vertical air grille
will swing from side to side for uniform distribution of
the air. The horizontal air grille has to be adjusted by
hand.
7. Functions
Press this button to select the following settings:
Automatic, Cooling, Air Circulation.
8. ON/OFF
Use only this button to switch the appliance on and
off.
Putting the air conditioner into
operation
POWER PLUG
Insert the power plug in a socket-
outlet.
STARTING
Press the ON button to start the
appliance. The current room
temperature appears in the
display (5). If the temperature is
over 23 °C, the cooling function
will start automatically. If the
temperature is below 23 °C, only
the fan will run.
SETTING
A FUNCTION
Press the FUNCTION button to
select the required setting:
- Automatic
- Cooling
- Ventilation
SETTING THE
TEMPERATURE
AND TIME
Press the ( button to raise the
temperature and the - button to
lower the temperature. Press the
TIMER button to set the operating
time with the buttons
∆
and .
SWITCHING OFF Press the ON/OFF button for the
appliance to be switched off
immediately.
To protect the compressor it is triggered with a
delay of 3 minutes after the appliance is switched
on. The same applies when the appliance is
switched off.
The function settings are cancelled when the
appliance is switched off or when there is a
power failure. You will need to reset the functions
as required.
The cooling system switches off when the room
temperature is lower than the value set on the
thermostat. Air circulation / ventilation continues
in accordance with the settings. If the room
temperature rises again, the cooling function will
be reactivated.
10
GB
Remote
control
receiver
∆
∆
Anleitung MKA 2500 7spr. 28.02.2005 10:56 Uhr Seite 10
