GB
- 15 -
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock,
fi
re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
2. Layout and items supplied
2.1 Layout
1. Angle stop
2. Parallel stop
3. Wheel guard
4. Cutting table
5. Water trough
6. Housing
7. Knurled screw for setting the angle
8. Scale for miter cut
9. Knurled screw for cutting wheel guard
10. Thumb screw for parallel stop
11. Holder for splitter
12. On/O
ff
switch
13. Switch housing
14. Carry-handle
15. Diamond cutting wheel
16. Outer
fl
ange
17. Side cover
18. Nut
19. Splitter
20. Fastening screws for splitter holder
2.2 Items supplied
Please check that the article is complete as
speci
fi
ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or su
ff
ocating!
•
Original operating instructions
•
Safety instructions
3. Technical data
AC motor .................................220-240 V~ 50 Hz
Motor rating: ............................. 800 W S2 10 min
Motor speed: ........................................ 2950 rpm
Insulation material class .......................... Class F
Protection type .............................................IPX4
Protection class ................................................. I
Cut length: ............................................ Unlimited
Jolly length: .......................................... Unlimited
Cutting height 90°: .................................... 34 mm
Cutting height 45°: .................................... 14 mm
Cutting table-Dimensions ....... 395 mm x 385 mm
Diamond cutting wheel ........... ø 180 x ø 25.4 mm
Weight: .......................................................9,2 kg
Anl_TC_TC_800_SPK9.indb 15
Anl_TC_TC_800_SPK9.indb 15
14.08.2017 09:42:22
14.08.2017 09:42:22
