GB
- 24 -
After switching on the equipment wait for the
equipment to reach its maximum speed of rotati-
on before commencing with the sanding/grinding
work.
6.2 Dry grinding
•
For coarse grinding it is recommended to use
the coarse-grained grinding wheel (5).
•
Turn on the grinding machine using the ON/
OFF switch (1).
•
Place the workpiece onto the workpiece
support (7) and slowly guide the workpiece
towards the grinding wheel (5) at the desired
angle to the point where workpiece and grin-
ding wheel make contact.
•
Move the workpiece slightly back and forth to
produce an optimal grinding result. This way
the grinding wheel (5) will be evenly worn. Al-
low the workpiece to cool down occasionally.
Caution!
If the grinding/sanding wheel becomes jammed
during operation, remove the workpiece and wait
until the tool reaches its top speed again. If ne-
cessary, use less force when moving the workpie-
ce against the grinding/sanding wheel.
6.3 Wet grinding
•
For fine grinding it is recommended to use the
fine-grained grinding wheel (6).
•
Check that the sealing plug (21) is fitted befo-
re you start wet grinding.
•
In addition, also check that there is enough
water in the water container (10) (a third of
the wet grinding wheel (6) must be standing
in water!).
•
Turn on the grinding machine using the ON/
OFF switch (1).
•
Grip the workpiece with both hands and lower
it slowly onto the grinding wheel (6).
•
You can also rest the workpiece on the teeth
on the water container and lower it onto the
grinding wheel (6).
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
8.4 Transport
Transport the machine only by lifting it by the
motor housing or by the base plate (9). Never use
safety devices such as the safety window (2), the
spark de
fl
ector (3) or the workpiece support (7)
for handling or transporting purposes.
Anl_TC_WD_200_150_SPK9.indb 24
Anl_TC_WD_200_150_SPK9.indb 24
23.06.2020 15:30:18
23.06.2020 15:30:18
