8
Wear safety gloves
Wear safety goggles
Wear ear-muffs
Wear a dust mask
1. Description of the machine (Fig. 1/2)
1
1. Base frame
1
2. Diamond wheel
1
3. Trough
1
4. Aluminium table
1
5. Angle stop
1
6. Rail fence
1
7. Guide rail
1
8. Safety hood for the cutting wheel
1
9. Handle
10. Star grip screw for setting the angle
11. Star grip screw for securing during transportation
12. Base frame
13. Cooling water pump
14. Hose
15. Motor
16. ON/OFF switch
17. Angle scale
2. Items supplied
Tile cutting machine
Trough (3)
Cooling water pump (13)
Angle stop (5)
Base frame (1)
3. Intended use
The TPR 200/1 tile cutting machine is designed for
the standard cutting of small and medium-size tiles
(glazed tiles, ceramic tiles or similar) which can be
accommodated by the size of the machine. It is
designed for DIY applications and craft businesses in
particular. It should never be used for the cutting of
wood or metal.
The machine should be used
exclusively for its intended purpose.
No other use
is permitted and the manufacturer will not accept
liability for any damages or injury resulting from any
such use; responsibility rests with the user/operator
in any such case. Only use cutting wheels which are
suitable for the machine. Saw blades should never
be used. Compliance with the safety instructions, the
assembly instructions, and advice and instructions
on operation contained in the operating instructions
also falls under the terms of intended use. All
persons operating or carrying out maintenance work
on the machine must be acquainted with the above
and be aware of all potential dangers.
In addition, strict compliance with the accident
prevention regulations in force in your area, as well
as all other general rules of health and safety at
work, is imperative. The manufacturer’s liability shall
be deemed void if the machine is modified in any
way and the manufacturer shall therefore accept no
liability for any damages arising as a result of
modifications. Even if the machine is used as
intended, certain residual risk factors cannot be
completely eliminated. For reasons of design and the
construction of the machine, the following
eventualities are possible:
Contact with the diamond cutting wheel where it
is not covered.
Contact with the diamond cutting wheel while it is
turning.
Defective diamond tips flying off the cutting
wheel.
Workpieces or parts of workpieces kicking back.
Damage to hearing if the ear-muffs specified are
not used.
4. Important instructions
4.1. General
Please read this manual carefully and pay particular
attention to the instructions contained within it. Use
this information to get to know the machine, its
correct operation and safety regulations (see
supplementary sheet) before using for the first time.
4.2. Additional safety instructions
Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
Wear safety goggles.
Wear ear-muffs.
Wear safety gloves.
Never use cracked diamond cutting wheels.
GB
Anl. TPR 200_1 30.03.2004 13:53 Uhr Seite 8
