AFTER SALES SUPPORT
www.einhell.co.uk
34
Set up
75W DETAIL SANDER – WZDS 75 K
0151 649 1500
1890 94 62 44
6. Fitting the Finger sanding attachment
6
and Sanding finger piece
8
(See Fig. 15a - 15g)
CAUTION!
Ensure that there is no residue of a grinding/sanding sheet, or a
pad left on the oscillating plate
4
surface (See Fig. 15a).
- With the power plug & cable
12
removed from the mains supply,
turn the detail sander upside down.
- Ensure that the screw
7
is not fitted into the hole in the
oscillating plate
4
and that there is nothing else fitted on the
oscillating plate
4
surface and that there is no residue left
behind on the oscillating plate
4
surface.
- Align and fit the finger sanding attachment
6
onto the
oscillating plate
4
(See Fig. 15a - Fig. 15b).
- Align and fit the screw through the finger sanding attachment
6
into the threaded hole in the oscillating plate
4
, and tighten
the screw, using a PH2 star-headed screwdriver (not supplied)
(See Fig. 15c - Fig. 15d).
- Only use a sanding finger piece of the correct size.
- Align a sanding finger piece
8
with the finger sanding
attachment
6
and fit by pressing together (See Fig. 15e - Fig.
15f).
CAUTION!
Ensure that the surface of the sanding finger piece is fitted flat!
- Remove a sanding finger piece
8
by gripping with the fingers
and peeling off the finger sanding attachment
6
(See Fig. 15g).
77014_4460595_11016_UG.indd 36
18/04/2017 1:18 pm