www.eisenblaetter.de
Tel.: +49 - 8171 - 93 84 - 0 Fax: +49 - 8171 - 93 84 - 55
PIPE - SNIPER
®
P I P E B E L T G R I N D E R
Maintenance:
Changing the carbon brushes:
Unplug the machine from the power point, take out the screws and open the service hatch. Disconnect
the attached wires, remove the carbon brushes and clean the housing using an air
compressor. Put in new carbon brushes (This must not jam in the maintenance hatch) and put in
the spring back in. Lastly place the service hatch and the fasten screws back into place.
Through the air inlet slots it is possible to see if the brushes are on fire. If there is a strong fire the machine switches
off. To avoid causing more damage to the machine, we advise you to send it to us.
Only original replacement carbon brushes must be used. Our warranty is void if the incorrect carbon brushes are
used.
Cleaning:
Prevent the build-up of metal dust inside the machine by regularly blowing it out with an air compressor.
Gearbox:
The screws on the gearbox must not be loosened during the warranty period or this will void the warranty.
The grease in the gearbox needs to be renewed approximately after 1,500 hours. This is done by firstly, loosening
the screws then replacing the old grease with approximately 16g of gear grease.
Warranty:
We have a 12 month guarantee (from receipt date) from all technical and mechanical parts, as long as there was
no third party interference.
Technical Data
Mains Connection
220 V ~ 50 – 60 Hz
(alternative 110 V ~ 50 – 60 Hz)
Power Input
1,750 Watt (1,600 Watt)
Speed
I
nfinetely adjustable from 1,000 rpm
up to
3,800 rpm
, with tacho-generator for
constant speed under load.
Belt Dimensions
40 mm x 780 mm
Weight
5.3 kg
It is easy to change the carbon
brushes: Open the service hatch by
removing the screws, replace the old
carbon brushes, close the hatch and
fasten the screws.
Changing the carbon brushes easier and faster
1
2
3
TIP
