PIPE - SNIPER
®
P I P E B E L T G R I N D E R
Changing Belts
•
Important: Only change belts with the motor turned off.
•
Tighten the T-Handle
•
Put the belt onto the machine over the roller guides
•
Release the T-Handle to fasten the belt
Tip: New grinding belts should be run without
pipe contact , then switch to the required
enclosure size!
Checking the Belt
•
Turn on the machine and check whether the belt runs
perfectly.
Tip: Put speed level on 'A'!
•
Turn the machine off
Your PIPE-SNIPER
®
is now ready.
Before grinding
Put the belt on the pipe
Use the T-Handle to enclose the pipe the desired
amount.
•
Important: For safety guide the machine using both handles.
After grinding
Important: T-Handle must be released before
removing the machine!
Remove
PIPE-SNIPER
®
from pipe
TIP
TIP
1
2
2
2
2
1
1
1
www.eisenblaetter.de
Tel.: +49 - 8171 - 93 84 - 0 Fax: +49 - 8171 - 93 84 - 55
Grinding Belt Adjustment
•
Roller shaft with spanner (SW 16)
hold it in place and then loosen the lever.
•
Align the lever parallel to the arm
•
Correct adjustment: The belt must fit exactly onto the roller,
readjust until ready.
•
Important: The angle the machine must make to the workpiece is 90°degrees, so that
the belt remains optimally adjusted. Run the belt first to see if there is some deviation
from the default load.
