P I P E - S N I P E R
®
P I P E / T U B E S A N D E R
Mounting of Abrasive belt
• Important: Band change with the engine off.
•
Pull back the T-lever
•
Put belt on PIPE SNIPER
®
•
release T-lever to tensioning the belt
Tip: First run the new sanding belt without touching
the pipe, then adjust to desired enclosure!
Checking of belt
•
switch on machine and verify the belt drive
Tip: Set speed to „A“!
•
If the belt runs not exactly on roller switch off the
machine. Sanding belt needs to be adjusted.
Your PIPE-SNIPER
®
is now operational.
Before grinding
Push sanding belt onto pipe
Slightly pull T- lever to the desired enclosure
and move at the same time PIPE-SNIPER
®
towards
the pipe
• Important: The maschine runs for safe by using both handles.
After grinding
I
mportant: T-lever must be released before
moving away from pipe!
Move PIPE-SNIPER
®
away from pipe
TIP
TIP
1
2
2
2
2
1
1
1
Sanding belt adjustment
•
he top contact wheel needs to be turned a little with wrench
(SW 16) at the same time loosen the black clamping lever slightly
•
Align the lever parallel to the arm
•
Correct adjustment: belt must run exactly on the roll.
When changing belts adjust again if necessary.
• Important: Align the machine to the workpiece at a 90 ° angle to optimally adjust
the belt. If the belt runs not exactly on the roll under load this deviation must
be considered when adjusting.
www.eisenblaetter.de
Phone +49 - 8171 - 93 84 - 0 Fax: +49 - 8171 - 93 84 - 55
