5
3. Operating Audio Functions
Increase/decrease in the signal volume:
The LED will flash
between RED and GREEN to indicate the desired change in volume.
When the maximum/minimum level is reached, the LED will stay lit
and be GREEN.
Increase/decrease in bass/treble levels:
The LED will flash between
RED and GREEN to indicate the desired change in the bass/treble
levels. When the maximum/minimum level is reached, the LED will
stay lit and be GREEN.
Mute:
If the unit becomes silent (mute activated), the LED will flash
once in RED. If the mute function is cancelled, the LED will flash four
times.
Loudness:
It reinforces the bass level in terms of the signal volume, assuming a greater
backing at a lower volume and a lesser backing at a higher volume. The LED will flash once in
RED if the loudness has been activated (backing) or four times if it is cancelled.
Mono/stereo reception:
When activated, this feature allows the FM stations to be received in stereo (the LED will flash
once in RED). When cleared, this feature only allows for mono reception (the LED will flash four times in RED).
Note: If the control unit's configuration is mono (see Installation Sheet supplied with this kit), the signal will always be
received in mono even if the signal received by the antenna is in stereo.
If the control unit is off, a brief press on the
will
gradually turn on the unit (between 1 and 2 seconds).
While the unit is gradually turning on/off, the LED will be RED.
Once the control unit is ready to receive additional commands from
the remote control, the LED will be GREEN.
When the control unit is off, the LED will be OFF.
ON/OFF key
Key Sequence
VOL
VOL
TREBLE
BASS
LOUD
M/ST
The
will turn on
with the audio and station
frequency settings saved as “ideal”
mode settings (see chapters 5 and
6) when the unit is connected to the
mains.
When switched off and on while
connected to the mains, the audio
and station frequency settings will
be as when the unit was switched
off with the remote control
ON/OFF key
KBSOUND®PLUS
ENG
CC-1088-05.1
