If multicast codec is G722, the LCD screen will displays "HD", which means
the phone is sending high-definition voice stream
Operate steps:
1
、
When the phone is idle, press multicast key
Multicast RTP stream is sended to pre-configured multicast address (IP:
Port)
。
The phone which listens to
multicast address in the local network
can receive the RTP stream. Multicast functionkey LED lights yellow.
LCD screen displays the following:
2
、
Press the hold softkey to hold the current multicast session
3
、
Press the end softkey again or
multicast functionkey, multicast session
can be stopped
Notice: RTP stream is one side, that is from a sender to a receiver. when
the phone initiates a multicast RTP session in a call,the current call is on
hold.
Receive
Receive
Receive
Receive multicast
multicast
multicast
multicast setting
setting
setting
setting
You can set up the phone monitoring 10 different multicast addresses to
receive these multicast RTP stream.
You have two method to receive RTP stream of multicast that can be set up
through the web page: Enable priorities of normal calls and Enable page
Priority:
