- 9 -
STEP 1
Use this opening
as an Inlet Port!
Tubing
EK-Fitting
INSTALLATION OF FITTINGS AND TUBING
STEP 1
EK recommends the use of EK-Fittings. When using fittings other
than EK series please use hose clamps or appropriate substitute
to secure the tubing to the barb. The use of biocide containing and
corrosion inhibiting coolant is always recommended for any liquid
cooling system.
CONNECTING THE D-RGB LED STRIP
Plug the 3-pin connector from Monoblock D-RGB LED light to the
DRGB HEADER on the motherboard. The LED will work if the pin
layout on the header is as follows:
+5V, Digital, empty, Ground.
Please ensure that the arrow indicated on the connector is
plugged into the +5V line as indicated on your motherboard.
Failure to do so will damage your motherboard or LED strip.
D-RGB Header
RGB Header
