Key Fob Battery Replacement
FlashLock and Key Fob Battery
1. Use a flathead screw driver to pop the back case off the Key
Fob. See Figure 1.
2. Pull the inner assembly out and remove the button case from
the circuit board. See Figure 2 for reference.
3. Remove the CR2032 battery from the circuit board by pushing
through the bottom. See Figure 3.
Be careful not to damage
the circuit board.
4. Replace the battery with positive face oriented upward. Push
the battery in until fully seated. See Figure 3 for reference.
5. Check functionality by pressing the button. LEDs will light if the
battery is connected.
6. Set the circuit board into the back case. See Figure 4.
Figure 1: Wedge off Back Case
Figure 2: Part Layout
Figure 3: Remove Battery
Figure 4: Set Board in Back Case
Back Case
Top Case
Button Case
Circuit Board
Button
V1.0_8101 | Division of Davcor Group Pty Ltd | www.ekacyberlock.com.au | www.ekacyberlock.co.nz
