TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 4 ___________________________________________________________________________________________
1. Technical service
A technical check-up once or twice a year helps prolong the life of the appliance and guarantees
better operation. Make sure that assistance is carried out solely and exclusively by qualified
personnel.
For any spare parts orders or for any information about the appliance, always mention the serial
number and model (data indicated on the "technical data" plate at the rear of the oven).
2. General warnings
Very important!: keep this instruction book together with the appliance for future consultation.
These warnings were drafted for your safety and for that of others. Please read them carefully
before installing or using the appliance:
-
If, on receipt of the goods, the packaging is damaged, write the following on the delivery
note: “I REVERSE THE RIGHT TO CONTROL THE GOODS”, specify the damage and get the
driver to sign in acceptance; send a claim in writing to the seller within 4 calendar days
from the date of receipt. No claim shall be accepted after such period.
-
The warehouse inside temperature must not be lower than -9°C; otherwise, the
thermostat (regulation and safety thermostat) control devices of the machine will be
damaged. Failure to observe this prohibition invalidates any responsibility of the
manufacturer of the machine.
-
The appliance is intended for professional use and must be utilised by qualified personnel
trained to use it.
-
Any modification which may be necessary on the electrical system to enable installation of
the appliance, must be carried out solely by competent personnel.
-
It is dangerous to modify or attempt to modify the characteristics of this appliance.
-
Never clean the appliance with direct water jets, because, if any water enters, it could limit
the machine's safety .
-
Before doing any maintenance or cleaning jobs, disconnect the appliance from the
electrical mains and allow it to cool.
-
When the tilting door is wide open, do not put anything on the surface, because the door
hinges could be irreparably damaged
.
-
Do not attempt to carry out the periodic controls or any repairs by yourself. Contact the
nearest Service Centre and use only original spare parts.
N.B.: Improper or incorrect use and failure to observe the installation instructions shall release the
manufacture from all responsibility. In this connection, the directives in the "POSITIONING"
paragraph must be strictly observed.
3. Technical specifications
Dimensions of appliance LxDxH (mm)
790x750x635
Weight (Kg)
50,4
Maximum load per tray GN1/1-600x400mm (kg)
4 – 2
Maximum load GN1/1-600x400mm (kg)
16 - 8
Convection heating element (kW)
6
Max. absorbed power (kW)
6,4
Power supply voltage (V)
380V~ (50/60Hz)
Power cable diameter
4x2,5 mm
2
Type of cable
H07RN-F
Connecting electric cable
Tipo Y
Class
I
Degree of protection against humidity
IPX3
The noise level of the appliance in operation is below 70 dB (A).
The "technical data" plate is positioned on the rear panel of the appliance.
