TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 12 __________________________________________________________________________________________
Changing the door seal
Changing the door seal
Changing the door seal
Changing the door seal - The door seal has a rigid profile with 3 fixing tabs. The profile must be
fitted into the guide on the face of the cooking chamber. The rectangular seal fits perfectly into
the frame of the guide and, therefore, the seal profile fits perfectly onto the face of the cooking
chamber. To change the seal, remove the old one from the guide by pulling hard at the four
corners. Clean any dirt from the guide and introduce the new seal (to make this operation
easier, we advise dampening the seal profile with soapy water).
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device
Resetting the thermal breaker safety device - This device is reached by removing the left side of
the appliance and can be reset by pressing the red key right down (which is marked by a special
adhesive label), which is inside the electric components compartment.
Possible faults
Possible faults
Possible faults
Possible faults
Type of fault
Type of fault
Type of fault
Type of fault
Cause
Cause
Cause
Cause
Corrective action
Corrective action
Corrective action
Corrective action
Control panel
completely off (the oven
does not work)
-
Incorrect electric connections to the
mains
-
Check the mains connection
-
No mains voltage
-
Restore mains voltage
-
Thermal break safety device tripped
-
Reset the thermal break safety
device
Cooking cycle set: the
oven does not work
-
Door open or ajar
-
Close the door
-
Damaged magnetic sensor
-
Contact a qualified technician to
repair the sensor
Automatic humidifier
ON: no steam is
produced in the cooking
chamber
-
Incorrect connection to water
mains
-
Check the connection to water
mains
-
Cut-off cock closed
-
Check the cut-off cock
-
Blocked water inlet filter
-
Clean the filter
-
Damaged water inlet solenoid
-
Contact a qualified technician to
repair the solenoid
Door closed: steam
comes out of the seal
-
Seal not fitted correctly
-
Check the seal fitting
-
Damaged seal
-
Contact a qualified technician to
repair the seal
-
Handle prong loosened
-
Contact a qualified technician to
repair the prong
The oven does not cook
evenly
-
One of the motors is blocked or
turns slowly
-
Contact a qualified technician to
repair the motor
-
The motors do not go into reverse
-
Contact a qualified technician to
repair the motor
-
Heating element not powered or is
damaged
-
Contact a qualified technician to
repair the element
Lighting lamp in the
cooking chamber does
not work
-
Damaged lamp
-
Change the lamp
-
Damaged lamp feeder
-
Contact a qualified technician to
repair the feeder
The thermo safety
device turns on in
continuous
-
Device damaged
-
Contact a qualified technician to
repair the feeder
-
Regulating thermo state damaged
-
Contact a qualified technician to
repair the feeder