eka KF 1010 EV UD Use And Instruction Manual Download

Page: 15 / 28

_ Electronic Ovens _ rev. 1 _____________________________________________________________ KF 1010 EV UD

_________________________________________________________________________________________ page 15 _

3.2.11

.2.11

.2.11 “Humidification” function

“Humidification” function

THE HUMIDIFICATION F

THE HUMIDIFICATION FUNCTION IS ONLY AVAI

UNCTION IS ONLY AVAI

UNCTION IS ONLY AVAILABLE FOR COOKING CY

LABLE FOR COOKING CY

LABLE FOR COOKING CYCLES WITH DRY OR

CLES WITH DRY OR

NEUTRAL CLIMATE (

NEUTRAL CLIMATE (RED LED OR WHITE LED ALIGHT ON THE CLIMATE LIGHTED BAR).

IT CANNOT BE ACTIVAT

IT CANNOT BE ACTIVATED WHEN THE STEAM GE

ED WHEN THE STEAM GE

ED WHEN THE STEAM GENERATOR IS WORKING

NERATOR IS WORKING

NERATOR IS WORKING ((((

BLUE LED ON

STEAM

CLIMATE

3.2.11.1 “Humidification” function with cooking cycle deactivated

.2.11.1 “Humidification” function with cooking cycle deactivated

To activate the “humidification” function press the

key and keep it pressed until the

second “beep” (the green led on the key goes off) and turn the knob “3” in an anticlockwise
direction (position 19 on the control panel), choosing the number of blue leds alight and,
therefore, the amount of humidity (the more

the more

the more blue leds there are alight the higher amount of

blue leds there are alight the higher amount of

humidity).

This operation can be carried out for each single phase of the cooking cycle or for each phase

of the cycle.

The “humidification” function can be managed in “manual” cooking mode or it can be

stored in the cycle phases with the other parameters (time / temperature / neutral or dry cycle)

neutral or dry cycle)

in “programmed” cooking mode.

Until the cooking cycle starts, the amount of preset humidity can be checked for each phase

of the cycle. Just keep the

key pressed until the second “beep” and the number of blue leds

alight is shown on the climate lighted bar (position 15 on the control panel. Keep the

key

pressed and turn the knob “3”, to change the number of lighted blue leds and the amount of
preset humidity.

When the cooking cycle starts, the green led on the

key flashes, confirming the

“humidification” function is active.

During the cooking cycle in “manual” mode, the “humidification” function can be

deactivated at any time and in any cycle phase by pressing the

key (the green led on the key

stops flashing and goes off).

3.2.11.2 “Humidification” function with the cooking cycle activated

.2.11.2 “Humidification” function with the cooking cycle activated

To activate the “humidification” function, press the

key (the beep sounds) and keep it

pressed, turn the knob “3” in an anticlockwise direction (position 19 on the control panel),
choosing the number of blue leds alight and the amount of humidity (the more blue leds there

the more blue leds there

are alight the higher amount of humidity).

Release the

key and the green led begins flashing confirming that the “humidification”

function is active.

By acting in the same way, the amount of preset humidity is changed.
During a multi-phase cooking cycle, the “humidification” function remains active for the

entire phase that it has been set for, after which humidification is automatically deactivated.

With the cooking cycle active, the amount of preset humidity can be altered only in “manual

cooking” mode.

In “programmed cooking” mode the stored parameters, and therefore humidification,

cannot be altered until the cycle ends. Consequently the “humidification” function cannot be
deactivated either.