__TECNOEKA Srl_______________________________________________________ use and instruction manual _
_ page 6 _____________________________________________________________________________________
Connection of power cable
Connection of power cable
Connection of power cable
Connection of power cable - The terminal board is on the rear panel of the appliance.
Open the terminal board cover by obtaining leverage with a screwdriver on the two side
fins. Loosen the cable gripper screw and allow the cable to pass through it. Arrange the
conductors so that the earth conductor is the last to detach from its terminal if the cable
goes into a state of faulty traction. Connect the phase
phase
phase
phase conductor to the terminal marked
with the letter "L"
"L"
"L"
"L", the neutral
neutral
neutral
neutral conductor to the terminal marked with the letter "N"
"N"
"N"
"N" and
the earth
earth
earth
earth conductor to the terminal marked with the symbol
. Tighten the ring-nut of the
cable gripper and close the terminal board cover. The appliance must be connected to an
equipotential system
equipotential system
equipotential system
equipotential system whose efficiency must first be checked according to current legal
regulations. This connection must be made between different appliances by using the
appropriate terminal marked with the symbol . The equipotential conductor must have a
minimum diameter of 2,5 mm
2
The equipotential terminal is at the rear of the appliance.
Safety thermal breaker
Safety thermal breaker
Safety thermal breaker
Safety thermal breaker - The appliance has a manually reset safety thermal breaker. It
protects against excessive dangerous over-temperatures which could be accidentally
generated inside the appliance. If the device is tripped, it interrupts electrical power to the
appliance and thus prevents it from operating.
5.
5.
5.
5. Use instructions (for the user)
Use instructions (for the user)
Use instructions (for the user)
Use instructions (for the user)
This appliance is not intended for use by persons (including children) with reduced phycal,
sensory or mental capabilities, or lack of experience and knowledge. Unless they have
beengiven supervision or instruction concerning use of appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance
For first use, we advise you to let the appliance to run load-free at maximum temperature
for about one hour. In this way, any unpleasant smells due to thermal insulation and residual
work grease are eliminated.
This appliance must be used solely for the purpose for which it was expressly designed,
i.e. cooking foods in the oven. Any other use is considered unsuitable.
The appliance can be used: for all oven cooking of deserts, pizzas, meat, fish, vegetables,
as well as for gratinating, and for re-conditioning cooled and frozen foods.
When placing food in the cooking compartment, leave a space of at least 40 mm
between pans in order not to over-obstruct air circulation.
Do not use pans with higher than necessary edges: edges are barriers which prevent the
circulation of hot air.
Warm up the oven before every cooking operation to obtain maximum uniformity.
Do not salt foods in the cooking compartment.
6.
6.
6.
6. Residual risks (for the user)
Residual risks (for the user)
Residual risks (for the user)
Residual risks (for the user)
After a cooking operation, open the door cautiously, to avoid a violent outflow of heat
which could cause burns.
While the oven is in operation, pay attention to the hot zones (marked on the appliance)
of its external surfaces.
Place the machine on a bench or similar support, at a height of at least 85 cm from the
floor.
The bench or support must be able to support the weight of the machine and house it
correctly.
The appliance contains electrical parts and must never be washed with a jet of water or
steam.
The appliance is electrically connected: before attempting any cleaning operation, cut
power to the appliance.
Do not use the door handle to move the appliance (the glass panel may break).
When the tilting door is wide open, there is the risk that things could be placed on the
surface with the risk of irreparably damaging the door hinges.
