5
Status LED
The meaning of the status LED under the programming
button is as follows:
•
Green steady on: normal operation and DALI line pre
-
sent
•
Flashing green: no DALI line
•
Flashing red: generic error on the output
If the programming button is not pressed within 1 minute,
the status LED goes into standby. A short press of the
programming button turns the LED back on and shows
the status.
Configuration change
Subsequently, it is possible to change the device confi
-
guration and addressing using an application for para
-
meterization, for example by downloading the ekinex
CGEKBG1TP software to the PC which allows you to:
•
configure the DALI system and define its parameters;
•
set the DALI devices (groups, scenarios, IDs, etc.);
•
test the communication on the DALI bus;
•
update the device.
The software can be downloaded from the website www.
ekinex.com and its use is described in the application ma
-
nual of the ekinex EK-BG1-TP DALI Gateway. The sof
-
tware works with Microsoft Windows (7 and later).
DT6 with single output channel
DT6 with 2 independent output channels
DT8 with single Tunable White output channel
DALI System fail function
For each device it is possible to set the “system failure”
parameter, that is the brightness level at which the LED
load is set, in case of DALI bus outage.
This setting can be done using a DALI programmer such
as USB DALI interface Tridonic, Lunatone DALI Cockpit
or similar.
The range of brightness values is from 0 to 254 (100%).
If the value 255 (MASK) is set, the last brightness value
is restored.
Note.
For the CGEKBG1TP configuration software
to work, it may be necessary to install .NET Fra-
mework 4, which can be downloaded freely from the
Microsoft website.
i
