22
10.2.2
When the not in use, it should be parked in a dry and ventilated garage to prevent the sun and rain, and
please note:
○
1 Turn off the electric lock, cut off the power and unplug the power plug;
○
2 After pulling up the stationary truck, the front and rear wheels are well parked.
○
3 In case of long-term disuse, the battery should be replenished every 15 days.
10.3 Check before Using
10.3.1
If the new vehicle is damaged during transportation, please do not put it into use and contact the supplier in
time for proper treatment.
10.3.2
New vehicles have been equipped with lubricating oil and hydraulic oil in the fuel tank.
10.3.3
Storage battery for the moving vehicle. The battery has been charged at the factory. If left factory for a long
time, the power may be low. Attention should be paid to the display of the electric meter before use. When the
electric meter is shown to the last two bars of warning, it must be charged immediately. Open the battery cover
every day before use or before charging. Check the level. If the level is too low, distilled water should be added before
charging. See (battery charging and maintenance) for details.
10.4 Safe Operation
10.4.1
Requirements for drivers: the vehicle must be operated by trained personnel;
10.4.2 Rights, obligations and duties of the driver:
the driver must clarify his rights and obligations and have
been trained in the operation of the vehicle; Be familiar with the operation manual. If the vehicle is pedestrian
controlled, the driver must also wear safety boots while operating.
10.4.3The use of unauthorized personnel shall be prohibited:
the driver shall be responsible for the vehicle
during the working period, and he must prevent the unauthorized personnel from driving or operating the vehicle. It
is strictly prohibited to use vehicles to transport or promote personnel.
10.4.4 Faults and defects:
the management must be notified immediately if the vehicle has a fault or defect. If the
vehicle can't operate safely (e.g., wheels are worn down or brakes are faulty), then be sure to stop using them until
they are fully repaired.
10.4.5 Safe operation and environmental protection:
the contents of inspection and maintenance must be
performed according to the time interval on the maintenance list.
Summary of Contents for EB18E
Page 6: ...5 EB20E ...
Page 12: ...11 6 Electrical schematic diagram ...
