5-3. Connection
１
Connect sensor connector on the sensor’s side to sensor connector on the tracker’s
side by using the attached cable. Make sure the cables are routed with sufficient
length when Sky Scanner is running. Avoid cable from wrapping around, getting
tangle or putting an extra strain on the sensor.
Fig.2-1 Connect the sensor cable
２
Connect communication connector to RS232C connector of PC with the cable.
Make sure the cables are routed with sufficient length when Sky Scanner is running.
Avoid cable from wrapping around, getting tangle or putting an extra strain on the
sensor.
３
Connect power connector to AC power supply with the cable. Make sure the cables
are routed with sufficient length when Sky Scanner is running. Avoid cable from
wrapping around, getting tangle or putting an extra strain on the sensor.
Fig.2-2 Connect the power cable and the sensor cable
Hang the sensor cable
on the altitude angle
axis before connection.
Be careful not to rap the
sensor cable around
leveling screws when
tracker is running.
Connect the power cable
and the sensor cable with
sufficient length as shown
in the left picture.
7
