background image

IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY

AND RETAINED FOR FUTURE REFERENCE.

   

When using this electrical appliance, basic precautions should be followed to reduce the risk

of fire, electric shock and injury to person, including the following:

• This heater must be used on an AC supply only and the voltage marked on the heater’s

rating label must correspond to the supply voltage.

• DO NOT switch the appliance on until it is properly installed as described in this

manual.

• This appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if they

have been given supervision or instruction concerning use of the appliance in a safe way and

understand the hazards involved. Children shall not play with the appliance. Cleaning and

user maintenance shall not be made by children without supervision.

• Children of less than 3 years should be kept away unless continuously supervised.

Children aged from 3 years and less than 8 years shall only switch on/off the appliance pro-

vided that it has been placed or installed in its intended normal operating position and they

have been given supervision or instruction concerning use of the appliance in a safe way and

understand the hazards involved. Children aged from 3 years and less than 8 years shall not

plug in, regulate and clean the appliance or perform user maintenance.

• CAUTION: Some parts of this product can become very hot and cause burns.

Particular attention has to be given where children and vulnerable people are present.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualified persons in order to avoid a hazard.

• The heater must not be located immediately below a socket-outlet.

• DO NOT use this heater in the immediate surroundings of a bath, a shower or a swim-

ming pool.

• WARNING: In order to avoid overheating, do not cover the heater.

• DO NOT use this heater with a programmer, timer, separate remote-control system or

any other device that switches the heater on automatically, since a fire risk exists if the

heater is covered or positioned incorrectly. 

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal

cutout, this appliance must not be supplied through an external switching device, such as a

timer, or connected to a circuit that is regularly switched on and off by the utility.

• Keep furniture, curtains and other fabric material away from the appliance.

• DO NOT leave the appliance unattended during use. 

• From time to time, check the cord for damage. Never use the appliance if the cord or any

part of the appliance shows signs of damage.  

1.0 IMPORTANT NOTES

I N S TA L L AT I O N   &   U S E R   I N S T RU C T I O N S

2

GB IE

Section

Contents

Page No.

1.0

Important Notes

2

2.0

Installation Requirements

3

3.0

Appliance Data

3

4.0

Unpacking the Appliance

3

5.0

Component Checklist

3

6.0

Clearances

4

7.0

Operating the Appliance                    5

Section

Contents

Page No.

8.0

Safety Cutout System

6    

9.0

Cleaning and Maintenance

6

10.0

Spares

6

11.0

Servicing

6

12.0

Troubleshooting Guide                           7

13.0

Appliance Dimensions

7

14.0

Guarantee - Terms and Conditions

8      

©

2016 Focal Point Fires plc.

Summary of Contents for MC01A









Reviews: