Manufacturer: PPHU
EKOLOT
Type: KR-030 TOPAZ
Handling, Maintenance and Periodic Inspections
Manual
Issue: 1
Rev. N
o
:
Date: July 2010
Date:
Page
43
5. Unscrew the eye nut J.12.131.00.01 from the front part of the rod
T.12.630.00.01
6. Remove the rod in the backward direction, holding the limiters cubes
J.12.630.04.01 down not to lose them (Pic. 3.9.10).
9.3.1.7 Installation of the main rod
T.12.630.00.01 of the rudder
control system
(can be carried out after removal of the elevator unit). Left side of the
rear part of the fuselage must be visible from the cockpit.
1. The rod J.12.630.00.01 without the eye nut J.12.131.00.01 is to be
moved to the fuselage and entered into the guiding eye. Guiding eyes of
the elevator system are located on the formers of right wall of the
fuselage.
2. When the tip of the rod reaches the front guiding eye it must be put by
hand to the eye from the cockpit.
3. When the tip of the rod reaches the limiter J.10.500.12.02 (Pic. 9.3.10)
the limiter cube must be put on it J.12.630.04.01 and drive the rod
through the limiter J.10.500.12.02.
4. Put the second cube on the tip of the rod J.12.630.04.01 and push the
rod in a way the joint head J.12.630.05.01 (Dwg. 9.3.2) is located close
to the ball J.12.640.01.00 (Dwg. 9.3.3).
5. The head J.12.630.05.01 should be pressed on the ball J.12.640.01.00
until a clicking sound is made.
6. Check if the rod is free to move in the eyes and rotation of the lever
J.12.641.00.02 in the bushing J.10.506.00.01.
7. Screw the eye nut on the front tip of the rod J.12.131.00.01.
9.3.1.8
Adjustment of the rudder control system, according to the
section 8, (after installing all elements of the control system,
according to the Dwg. 9.3.1, except the connection of the main
rod (1) with the intermediate lever (3)).
