INSTRUCTIONS FOR USE
NP-DK50 F-19_07-2021
16
07/2021
13.3 Replacement of inlet filter
(Fig.6)
Every two years it is necessary to change the filter insert (1) located in the
lid of the compressor engine case.
●
Pull out the rubber plug by hand (2).
●
Remove the dirty filter.
●
Insert a new filter and replace the rubber plug.
13.4 Replacement of a filter bed in a filter-regulator
(Fig.7)
Release the catch (1) on the filter by
pulling down, rotate the vessel (2) and pull
out.
Pull out the holder with filter (3),rotate and
take out from the vessel.
Rotate the filter retainer (4).
Replace the filter element (5) and reinstall
the filter retainer (4), secure by rotating.
Place the filter bracket (3) back into the
vessel and rotate to secure it in the place.
Reinstall the filter housing and rotate to
secure it until the catch clicks..
Filter -regulator
Order number
Filter bed
Order number
AW20-F02CH-A-PU
025200221-000
AF 20P-060S 5
m
025200113-000
14. STORAGE
If the compressor will not be used for a prolonged time period, drain any condensate from the air tank.
Then turn on the compressor for 10 minutes, keeping the drain valve open (1) (Fig.5). Switch off the
compressor by switch (3) at pressure switch (2) (Fig.4), close the drain valve and disconnect the appliance
from the mains.
15. DISPOSING OF THE APPLIANCE
Disconnect the appliance from the mains.
Release air pressure in the pressure tank by opening the drain valve (1) (Fig.5).
The components of the product are non-toxic.
Dispose of the appliance following all environmental regulations.
16. REPAIR SERVICE
Guaranteed and post-guarantee repairs must be done by the manufacturer, its authorized representative,
or service personnel approved by the supplier.
The manufacturer reserves the right to make changes to the appliance without notice. Any changes made
will not affect the functional properties of the appliance.
17. SOLVING PROBLEMS
Risk of electric shock.
Before any of the following operations on the device, disconnect the device from the
mains (pull out the mains plug).
Risk of injury during work with pneumatic components under pressure.
Before any of the following operations on the device, it is necessary to decrease
pressure in the air tank and in the pneumatic system to zero.
Fig.6
1
2
1
2
3
3
3
4
3
5
3
Fig.7
Summary of Contents for DK50 F
