eks Microsense 8009, User Manual

Specifications

1. Temperature measurement range:  34-42.2°C (93.2~108°F)

2. Operating temperature range: 10~40°C (50~104°F)

3. Storage temperature range: -20~50°C (-4~122°F), RH≤85%

  Transportation temperature should be less than 70°C, RH≤95%

4. Compliance with ASTM E1965-98, EN12470-5:2003 Clinical thermometers - 

  Part  5:Performance of infra-red ear thermometers (with maximum device), 

  IEC/EN60601-1-2(EMC), IEC/EN60601-1(Safety) standards.

5. This mode converts the ear temperature to display its “oral equivalent.” (according to the  

  result of the clinical evaluation)

6. °C / °F switch function

7. Battery: one lithium battery CR2032

8. Auto power shut-off

9. Ac/-0.2°C (0.4°F), 35.5~42°C (95.9~107.6°F);  +/-0.3°C (0.5°F) for other range.

Using the thermometer

1. Gently squeeze the sides of the probe cap and twist to 

  remove. Do not use force in removing the cap.

2.  Always use a new and undamaged probe cover.

  Attach the probe cover to the connection ring. Fig.1

Important: 

Place the smooth side (not the adhesive 

Caution! Read the instructions before use!

Warning:

 Proper installation of the probe cover ensures accurate 

  measurements. If the probe cover has not been connected firmly,  

  the probe cover icon

will flash on the display. In this case  

  please check the setting of the probe cover again.

  Warning: 

Keep the probe covers and connection ring away from  

  children.

3. Make sure the ear passage is clean.

4. Press the 

ON/MEM

 button. The thermometer is ready 

  for use after the ear icon stops flashing and two beeps sound.

5. Gently pull the ear back and up to straighten the ear passage. Fig. 3 

  To obtain the most accurate reading snugly position the 

  probe in the ear so that the probe point is in line with the 

  membrane of the eardrum.  Fig. 4

6. With the index finger press the 

SCAN

 button until you hear a  

  beep. Fig. 5

7. The device will shut off automatically if not used for more than 1  

  minute. This saves battery  life.

•  Place the center of the probe cover over the end of the probe.

•  Insert and push the connection ring until the probe cover  

  clicks into place. The “click” means that the probe cover has  

  been connected firmly. Fig. 2

Fig.1

Fig. 2

Fig. 3

Fig. 4

Fever alarm:

If the thermometer detects a body temperature of more than 

37.5°C when measuring by the ear or forehead, there will be a 

long beep sound followed by three short beep sounds which 

warn of potential fever.

Memory - MEM

If the temperature reading is within the normal range of 34 °C to 

42.2 °C (93.2 °F to 108.0 °F) when the thermometer is turned off, 

the last measurement is saved in the memory.

To recall the previous temperature press the 

ON/MEN

 button 

once again.

Fig. 5

2

3

4

GB