eks Microsense 8009, User Manual

Battery replacement

When the battery icon in the display flashes, the battery should be replaced.

•  To open the battery cover: Insert a pointed object, such as a pin, into the battery pin hole. 

  At the same time push the battery cover backwards.

•  Flip out the battery with a small screwdriver.

•  Insert the new battery under the metal hook on the left side and 

  press the right side of the battery down until it clicks into place. 

•  Replace the battery cover.

    ! The positive side ( + ) up and the negative ( - )side down.

    ! Keep the battery away from children.

Display message                     

Problem 

                   Solution

°C / °F switch:

When the thermometer is turned off, press the 

SCAN

 button and then press and hold the 

“

ON/MEM

” button until the icon for °C (Centigrade) shows in the display. The same procedure 

to change to °F (Fahrenheit).

Care & cleaning

The probe is the most delicate part of the thermometer. Handle with care when cleaning the 

lens to avoid damage.

•  Storage temperature range: -20~50°C (-4~122°F), RH≤85% 

•  Keep the unit dry and away from any liquids and direct sunlight. 

•  The probe should not be submerged in liquids.

•  If the device is accidentally used without a probe cover, clean it as follows:  use a cotton  

  swab with alcohol (70% concentration) to clean the lens.

•  Allow the probe to dry completely for at least 1 minute.

Note: 

•  If the device is dropped, please check that it is not damaged. If you are not sure if it is  

  damaged, please send the complete devise to the nearest retailer for recalibration.

•  If you hold the thermometer for a long time it may cause the devise to give a higher   

  room temperature reading. This can even affect body temperature measurement to be  

  lower than usual.

Device stabilization in progress 

Wait until        stops flashing.

Battery is low and no more  

Replace the battery.

measurements are possible. 

Measurement before device  

Wait until         stops flashing

stabilization. 

The device shows a rapid room 

Allow the thermometer to rest in a   

temperature change 

room for at least 30 minutes at room  

temperature:

10 °C - 40 °C (50 °F -104 °F).

The room temperature is not  

Allow the thermometer to rest

within the range 10 °C - 40 °C  

in a room at least 30 minutes

(50 °F -104 °F) 

at room temperature: 

10 °C -  40°C (50 °F -104 °F).

5

6

7

8

Trouble shooting