4
Connect this part to the power
supply
Connect this part to the PC
2. Installation and wiring
1. Fasten the digital encoder-modulator module to a wall frame (CHM TR) or a rack chassis
(CHR TR). To this end assemble on the upper rear part of the module the supplied metal part,
as is shown in the picture
2. Connect the power supply (FA 524) to the module or either connect same to the previous
module using the supplied power cable
3. Connect the HD audio/video power supply to the HDMI connectors
4. So as to program the module, connect the FA 524 power supply to a PC via a USB-USB
cable as follows:
5.
Install the “CMManagement” software on the PC or the or the "EK Pro" software package
which is also included. Both programmes can be downloaded from the website
www.ekselansbyits.com
, Documentation >> Software section.
6. Run the programming software on the PC (
Important
: connect the FA 524 power supply to
the PC before running the software so that the driver of the PC can correctly detect the
software).
