8
In order to program the module, connect in the first place the audio/video sources which are
wished to be connected to the HDMI connectors of the CM 4HD-IP module. Each HNMI input
can be assigned a set of values, such as:
SSID: Unique identifier of the program
Nam.: Software name
Audio type: to be selected between AAC and MPEG
Video rate: defined as the default at 9000 Kbps, which can be changed specifying the value
Audio rate: defined set as the default at 192 Kbps, which can be selected from a predefined
list
3.2.1 Conversion of the IP input services
Once the audio/video power supply is connected to the corresponding HDMI input jacks, all
these will appear at the bottom of the screen. From here one can make his/her assignation to
each of the two IP streams available in the output (up to 16). As shown in the figure below, in the
section shown in red the 16 available streams (from A to P) are displayed.
HDMI Inputs
IP Output
Output programming
parameters
Service selection per IP
stream
