5
Chapter 4 S
A F E T Y
Equipment is designed to be safe under normal environmental conditions according to
1.4.1. 61010-1@IEC:2010 (Safety requirements for electrical equipment, control and
laboratory use):
a) indoor use;
b) altitude up to 2000 m;
c)
temperature 5ºC to 35˚C;
d)
maximum relative humidity 80% for temperatures up to 31ºC decreasing
linearly to 50% relative humidity at 35ºC;
e) POLLUTION degree 1: no POLLUTION or only dry, non-conductive
POLLUTTION occurs.
Warning:
The safety of the system incorporating driver and HV power supply is the
responsibility of the assembler of the system.
Operating the driver is allowed to persons acquainted with the operation manual and
having permission to deal with voltages over 1000 V.
Do not remove unit covers while power cable is connected to the mains (if applicable).
Do not touch any parts of the system when high voltage is applied, as it may cause
human injuries or death.
Do not operate the unit until it is
grounded
and the load is connected.
Do not use the unit if any defects have been detected
.
