- 4 -
RECOMMENDED RESERVOIR CONFIGURATION
The InWin 303EK includes a pre-installed distribution plate that is
equipped with an EK-DDC 3.2 PWM pump. Please, read this manual
before installation. For details about the case, refer to the supplied
InWin 303 manual.
ATTACHING THE FITTINGS
STEP 1
In order to complete your loop, all of the ports should be used as
marked on the diagram. One port of each type must be used. In
the eventuality that a GPU or CPU block is not installed into the
system, the respective inlet and outlet still must be connected to
each other.
To make the installation of the tubing with different motherboard
configurations easier, there are multiple connection options for
the GPU. One of the inlet and one of the outlet ports must be used.
All remaining and unused ports should be closed using the
supplied plugs and a 6mm Allen key.
EK recommends EK Classic and EK-Torque series fittings.
STEP 1
GPU INLET
(one must be used)
DRAIN
GPU OUTLET
(one must be used)
CPU OUTLET
CPU INLET
RADIATOR
OUTLET
RADIATOR INLET
FILL
