- 4 -
PREPARING YOUR GRAPHICS CARD
STEP 1
REMOVING THE STOCK COOLER
Remove all encircled screws using Phillips screwdriver. All heat sink
assembly screws should be removed, including self-adhesive washers
on both sides of the PCB(if present). Also remove the IO bracket.
STEP 1
STEP 2
CLEANING THE PCB
Carefully detach the original stock cooler after removing all screws
securing in to the board. Wipe off the remains (by using nonabrasive
cloth or q-tip, as shown on sample photo) of the original thermal
compound until the components and circuit board are completely
clean. EKWB recommends the use of denatured alcohol for removing
TIM leftovers.
STEP 2
