All disclosures, notices and warranty conditions are being written on the back of the box.
Released on 10
th
of March, 2010.
STEP 6. ATTACHING BACKPLATE for Intel 1366 Socket
STEP 7. ATTACHING BACKPLATE for AM2 and AM3 Socket
When using motherboard with Intel 1336 socket, insert screws at positions as
shown bellow. Standoffs are used to prevent possible overtightening of screws
and causing potentional damage to PCB.
When using motherboard with AM2 and AM3 socket, insert screws at positions
as shown bellow. EPDM rubber is used as insulator, therefore it must be used
underneath the metal backplate.
STEP 8: ATTACHING BACKPLATE for Intel 1155/1156 Socket
STEP 9: CONNECTING WATER BLOCK TO CIRCUIT
When using motherboard with Intel 1155/1156 socket, insert screws at
positions as shown bellow. Standoffs are used to prevent possible
overtightening of screws and causing potentional damage to PCB.
Carefully identify the direction of the flow in your circuit. For the EK-SUPREME
HF Cu to operate properly, the fitting nearer the center of the water block
MUST BE USED AS THE INLET. To secure the tubes stays properly on the
fittings please use hose clamps or appropriate substitute. The use of an
algaecide is nonetheless recommended in any liquid cooling system.
IMPORTANT DISCLOSURES
VERY IMPORTANT NOTICE:
Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the
computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top
of the housing and render the block unusable (and will void your warranty).
While all efforts have been made to provide the most comprehensive tutorial possible, EK Water Blocks assumes no liability expressed or implied for any
consequential damage(s) occurring to your equipment as a result of using EK Water Blocks cooling products, either due to errors or omissions on our part in the
above instructions, or due to failure or defect in the EK Water Blocks cooling products.
WARRANTY:
Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During
this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was
purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled
carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer
rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and
does not affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives.
REQUIRED TOOLS
philips screwdriver
M4x50 screw
Standoff
Metal backplate
EPDM rubber
Metal backplate
M4x50 screw
IN
OUT
M4x50 screw
Metal backplate
Standoff
EPDM rubber
