/ 27 /
The best part of custom water cooling loop is that the system can be extended and the cooling capacity can be extended almost without limitations.
Rule of thumb is to use at least one 120mm radiator (section) per each water cooled component plus one ‘spare’.
For example, if one is liquid cooling a CPU and a single high-performance graphics card it is recommended at least one 240mm (2x 120mm) radiator
for good performance. Ideally, one would get a 360mm (3x 120mm) radiator for best performance. Motherboard- and memory water blocks usually
have lower power output therefore they are not included in this equation.
In this manual we will expand the loop with an additional GPU full cover water block. You can also expand the loop with an additional radiator, reservoir, motherboard block…
POSSIBILITIES OF ExPANDING THE SYSTEM
STEP 1
If already filled, drain the water cooling loop according to
the instructions in the chapter DRAINING OF THE LOOP.
Install the unit, with which you are expanding the system according
to its installation manual. When positioning it in the loop take notice
that water blocks must receive the coldest coolant as possible.
Carefully determine the optimal tube routing and install the compat-
ible fittings (10/13mm) and optionally the plugs.
STEP 1
