El-Björn A 75FT, Manual

137344

WARNING!

The dehumidifier must not be covered so 

that the air inlet or air outlet are obstructed.

The filter should be replaced 1–2 

times per year. Also refer to the 

“Maintenance” section.

Read the instruction manual carefully and ensure 

you understand the content before using the 

dehumidifier.

1-2 times / year

604503

7

INTRODUCTION

DESCRIPTION

Drying room dehumidifier A 75FT is designed for heavy personnel drying rooms associated with the construction and industrial 

sectors. The dehumidifier is intended for use in heated rooms + 15-35ºC.

The A 75FT is a condensation dehumidifier, and is based on the principle that air moisture condenses on cold surfaces. 

The surface of  the evaporator is cooled as the compressor transfers heat from the evaporator to the condenser.

The dehumidifier is equipped with a fan that transports the air through the dehumidifier. The air first passes through a replaceable

progressive filter. After this the air passes to the evaporator, where the moisture condenses and is deposited on the evaporator.

The water is collected in a tray fitted under the evaporator and is drained away. The air then passes through the fan and the 

condenser. In the condenser, the air is warmed up and the condenser is simultaneously cooled. If necessary, the air can then be 

heated in the thermostat-controlled heating coil before leaving the dehumidifier. The dehumidifier housing is made of powder-

coated aluzinc sheet.

NOTE!

The section concerning safety shall be read and understood by all who use or repair the A 75FT dehumidifier. These instructions 

regard operation and maintenance that can be performed by the operator. More detailed service or troubleshooting may only be 

performed by the manufacturer’s service staff. The user instructions describe all the necessary safety features. The user should read 

the instructions carefully before connecting the A 75FT dehumidifier to the electrical supply. In other words, the first action after 

delivery is to read through the operating instructions. Symbols and warning signs that appear in these instructions and on the 

A 75FT dehumidifier are shown on this page. If  any of  the warning signs on the A 75FT dehumidifier are damaged or worn, new 

signs must be ordered and attached as soon as possible to ensure maximum safety during use of the A 75FT dehumidifier. 

The dehumidifier may only be used for the purposes described in these instructions.

The manufacturer reserves the right to make changes.

GB

Safety during assembly

Electrical connection to power outlets and any additional 

equipment, e.g. timers, shall be performed by a qualified 

electrician.

Safety during use

The humidifier’s air inlet and outlet must never be covered 

during operation. Protective hoods and cover plates must  

never be removed during operation.

•  The device may be used by children over the age of  8,  

persons (including children) with physical or mental 

disabilities or lack of  knowledge or experience, provided 

they have received instruction or information on safe use  

of  the device and understand the potential risks. Children 

may not play with the device. Children may not clean or 

perform maintenance on the device without supervision.

• 

However, the product is suitable for use in situations 

where there are persons (including children) with reduced 

physical or mental capacity or diminished responsibility. 

•  If  children are in the proximity of  the product, they  

must be informed that the product must not be used as  

a toy or a plaything.

SAFETY

Warning signs and instructions on the product

Safety during service/maintenance

Before performing any maintenance work on the dehumidifier, 

the dehumidifier must be disconnected from the electrical 

supply. This is done by unplugging the connector from the 

power socket or by turning off  the operating switch.

All maintenance on the electrical system must be performed  

by qualified electricians.

All maintenance on the cooling system must be performed  

by qualified cooling technicians.

Always wear protective gloves when cleaning the evaporator

and condenser, to avoid cuts.

PERSONAL PROTECTIVE EQUIPMENT

Use gloves when replacing the air filter. Put the spent filter 

in a bag and close it.

Always wear protective gloves when cleaning the evaporator 

and condenser, to avoid cuts from the sharp fins.

MINIMUM EXPERTISE REQUIRED

Any service and installation work must be performed by 

authorised staff  or the manufacturer.