El-Björn A 75FT, Manual

9

GB

EXTERNAL FANS

To improve air circulation a fan is supplied, which should be mounted on a wall or on 

the ceiling. Two variants of  fan are available.  The first variant comes with a 15-metre 

cable that is connected to the socket on the dehumidifier, next to the week timer on the 

left side of the machine.

The second variant requires permanent connection, and must be installed by a qualified 

electrician.

The fan installed in the drying room must not blow directly towards the dehumidifier’s 

inlet or outlet. The fans must be controlled by the timer.

See wiring diagram in the dehumidifier or 

www.elbjorn.com.

OPERATION

WEEK TIMER

See separate manual.

THERMOSTAT (GT1:1)

Thermostat GT1:1 controls the heating coil and is adjustable from 0 to 9  

(corresponds to approx. 0–50°C).

The thermostat is located inside the filter hatch.

Remove the upper screws on the filter hatch. Hinge down the hatch. The thermostat 

is inside the front panel of  the electrical box.

Standard setting = 6

Overheat protection (GT1: 2)

GT1: 2 is an overheating protection that is placed in the heating coil and cuts the power 

to the tubular element at 90ºC. GT1:2 manually reset when the temperature drops.

Overheat protection (GT3)

The GT3 is a thermal protection that is placed in the heating coil and breaks

control current to the tubular element at 70ºC. The GT3 is reset automatically  

when the temperature has dropped.

HUMIDISTAT

A humidistat is fitted inside the dehumidifier and this can be set using a knob behind 

the filter access door (door panel) at the bottom left of the dehumidifier. The setting 

range is 20–80%, which is a measure of  the relative humidity (RH). The normal range 

of  RH for an indoor climate is 50–60%. The average value is given as 50%.

RESET

604242

0

1

2

3

4

5

6

7

8

9

GT1:1

GT1:2