ELAD TM-2
User Manual - Rev 2 - 05/2021
© 2021 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated
in any form or by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
8
Step2.
Configure the Perseus software :
Click on the top title bar icon in front of PERSEUS and the about window will pop up, then click on
software settings, and make sure the Virtual COM port is set to COM10 (this can be changed, as long as
it matches the VSPE Connector). Then in the bottom right you should see VCom ON, if it says VCom Off,
then you need to make sure the virtual com port software is running.
