3
2
1
Scuffguard
EK 044
Product Sleeve
EK 043
Push Product Sleeve (or Splashguard EK 652) over
the Scuffguard.
While pushing the Product Sleeve, turn it until it
snaps in properly onto the Scuffguard.
Pay attention to the correct fit of the
Product Sleeve
:
1) Correct position of the Scuffguard, the nozzle
body has to be visible.
2) The Product Sleeve has to snap into the Scuff-
guard: no gap between these two parts allowed.
3) The parting line on the Product Sleeve has to be
in line with the parting line of the Scuffguard.
September 2012
Assembly of Product Sleeve EK 043
Assembly of Product Sleeve EK 043
