Insert LeverAssist part as shown.
... and drive it in with a vice.
The lever should look like this now.
Take supplied 'ramp' for the LeverAssist ...
... and push it into the guard as shown.
Control lever pins EB 235. Assemble guard.
Tighten front + rear guard screws.
Assemble scuffguard. Push product sleeve ...
... over scuffguard until it snaps in properly.
Test function.
Re-insert bolt EB 031 ...
This side up
Legs of ramp must snap in properly.
✔
✔
EB 235
Please note:
Modifications to nozzles must only be done by suitably trained technicians. Observe safety regulations and safe work
practices for petroleum handling equipment on forecourts.
