VIA!4.0-EM/VIA!7.0-EM/VIA!10.0-EM E L A N H O M E S Y S T E M S
Page 28 © ELAN Home Systems 2007 • All rights reserved.
Removal From Wall
(Winglets Deployed)
Use a thin steel ruler or thumbnail to slip under the bottom
edge of the faceplate and gently pry it off the assembly.
Loosen the winglet screws until they retract inside the metal
mounting box. Look through the openings in the mounting flanges
to verify that the winglets have fully retracted. If they have not fully
retracted you can insert a small diameter screwdriver in the adja-
cent hole to guide the winglets into the box. Do not apply
too much force on the winglets as they may cause damage to
the
circuit
board.
Gently pull the top of the VIA! assembly out of the wall first
and then slowly lift the rest of the assembly out of the wall. Stop im-
mediately if the winglets grab the drywall or fracturing of the drywall
may
occur.
Lift the assembly up until the wires along the bottom edge are ex-
posed. Label, disconnect and tie off the wires to keep them from
dropping down inside the wall. Make sure to protect the touch
panel/LCD assembly and faceplate from damage when it is not in
the
wall.
Front
Figure 3.16: Removal From Wall
1.
2.
3.
4.
