Elation EWDMX IP, User Manual

w w w . e l a t i o n l i g h t i n g . c o m

13

EWDMX IP™ User Manual ver 1 

O P E R A T I O N   G U I D E  

SYNCRONIZING RECEIVERS TO A TRANSMITTER 
Note: You can add receivers at any time, even during operation. 

1.

Power on the 

RECEIVER

 unit(s) and ensure that they are not linked with any other 

TRANSMITTER

  (LINK  indicators should be OFF  and RX indicator should be ON). If 

the units are linked, follow the instructions in the next section to unlink receivers. 

2.

On the 

TRANSMITTER

  unit, press and release the 

RED  FUNCTION

  button quickly.  

The

 TRANSMITTER

 will scan for all unlinked 

RECEIVERS 

for a period of ten seconds - 

the LINK indicator will flash rapidly.     

If successful, each 

RECEIVER’s

 LINK and SIGNAL indicators will go ON. If failed (i.e. the 

LINK  indicator fails to go solid after 10 seconds on the 

RECEIVER

), check if the 

RECEIVER

 is in range and repeat the procedure. 

 
CLEARING A RECEIVER LINK TO A TRANSMITTER   

On the 

TRANSMITTER

 unit, press the 

RED FUNCTION

 button and hold for 3 seconds. All 

display LEDs will go out, and the LINK LED will be blinking slowly. Release the 

RED FUNCTION

 button at this point, and all connected 

RECEIVERS

 will be unlinked.     

 
TO UNLINK AN INDIVIDUAL RECEIVER 

On the 

RECEIVER,

 press and hold the 

RED  FUNCTION

 button until the LINK indicator 

goes OFF except for POWER and RX indicators. The 

RECEIVER

 is now unlinked.     

 
SWITCHING BETWEEN TX AND RX MODES 

The 

EWDMX IP

™

 can switch between transmit and receive modes, allowing the unit 

to be used as a TRANSMITTER or a RECEIVER.   
1.

Remove power from the unit by disconnecting the power cable 

2.

Push and hold the 

RED FUNCTION

 button 

3.

Reconnect power while still holding the 

RED FUNCTION

 button 

4.

Release the 

RED FUNCTION

 button 

5.

The TX (TRANSMITTER) or RX (RECEIVER) LEDs indicate the mode of the unit.