Power Spot 700™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page
20
current DMX address immediately after the reset sequence. If the fixture is not
receiving a DMX signal the display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the
POWER SPOT 700™
and wait for the fixture reset process to
finished (
'RESE'
will flash in the LED while fixture is in reset mode).
2. Press the
Mode
button to access the main menu. Toggle through the menu by
pressing the
Up
and
Down
buttons until the display shows D001. Tap the enter
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the
Up
and
Down
buttons
to
select adjust the address. Lock your new address into the unit’s memory by
pressing the
Enter
button. After the new address has been successfully stored
into the fixture’s memory the LED will briefly readout
OK
.
The DMX address is non-destructible and will remain in the fixture’s memory even
when the power has been switched off. Memory is backed-up and retained by an
internal power source with a five year shelf life.
3.2 Test Program
Test
The
Test
Program engages the fixture’s internal test mode. This function runs a
complete test procedure of all functions. Press
Enter
to launch the self-test or the
Mode
button to cancel and return to the main menu.
3.3 The Audio Program
AUDI
The
Audio
menu allows you to run a stand-alone audio program. This program can
run either fast (
AFST
) or slow (
Aslw
); Fast (
AFST
): When running in “fast” mode
every sound impulse will trigger a new step. (
Aslw
): When running in You may run
