Elaut NV
Ticket_Circus_1.2_ENG
13
SAFETY
The machine may only be installed by a qualified person.
Machine installation must satisfy the current applicable standards.
Switch off the power supply before commencing installation or maintenance
work.
Do not open or disassemble the machine. Opening the machine can prove
hazardous and will void the warranty.
If connected, the machine or its components are powered by a 230V power
supply.
Make sure that the power cable is connected properly.
Do not plug or unplug a cable, while the machine is switched on.
Do not plug this system into a supply voltage other than indicated on the
machine label.
The operator is responsible for the proper installation and machine use. An
incorrect installation may result in product damage or shortcomings. The
warranty will become void, if the machine and/or electronic components are
damaged due to an incorrect installation.
MOVING PARTS
The upper compartment of the machine can be opened by unlocking the key-
locked glass door. When opening this door using the push lock, the mechanical
movement will be interrupted. The operator can cancel the shutdown by
resetting the door switch.
You can use this compartment to access the playfield. It is constructed in such a
way that it cannot cause physical injury. Its drive mechanics are part of the
lower compartment.
The lower compartment of the machine can be opened by unlocking the key-
locked wooden door. When opening this door using the T lock cabinet handle
(see
), the mechanical movement will NOT be interrupted.
Moving lift parts which might cause injury, are guarded by transparent covers.
Please switch off the machine when removing these covers, in order not to get
hurt by moving parts. When opening the key-locked glass door, new commands
will be interrupted, yet initiated requests will be handled until the end of the
envisioned cycle. When closing the key-locked glass door, a lift cycle will
explicitly be initiated. This is a practical way of solving the lift blockage due to
win items or coins from the playfield. Be careful and stand clear of moving
parts as your fingers may be injured.
THERMAL AND ELECTRICAL SAFETY
In order to minimize the risk of ignition, component temperatures are limited
to safe levels. The hottest components are resettable fuses that use thermal
PTC features. Their off-state temperature is max. 125°C.
The earth leakage current is less than 1mA.
