35
ADJUSTING OF THE MINIMUM OF
THE TOP BURNERS
In the minimum position the flame must
have a length of about 4 mm and must re-
main lit even with a quick turn from the ma-
ximum position to that of minimum.
The flame adjustment is done in the fol
-
lowing way:
•
Turn on the burner.
•
Turn the tap to the MINIMUM position.
•
Take off the knob.
•
With a thin screwdriver turn the screw
F
until adjustment is correct (fig. 9.6).
Normally for LPG (G30/G31), tighten up
the regulation screw.
F
Fig. 9.6
REPLACEMENT OF THE INJECTORS
Select the injectors to be replaced accor-
ding to the “Table for the choice of the
injectors”.
If the injectors are not supplied they can
be obtained from the “Service Centre”.
REPLACEMENT OF THE INJEC-
TORS OF THE COOKTOP BUR-
NERS
To replace the injectors proceed as follows:
•
Remove pan supports and burners
from the cooktop.
•
Using a wrench, substitute the nozzle
injectors “
J
” (figs. 9.4, 9.5) with those
most suitable for the kind of gas for
which it is to be used.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
J
Fig. 9.4
J
Fig. 9.5
Auxiliary,
semi-rapid
and rapid
burners
Triple-ring
burner
Summary of Contents for ENTWIN 90 DF
Page 2: ...2...
Page 20: ...20 S F C T Fig 7 1 Fig 7 2 A B S T Fig 7 3 Fig 7 4 Fig 7 5...
Page 38: ...38...
Page 39: ...39...
