36
The appliance must be connected to the electrical network verifying above all that the
voltage corresponds to the value indicated on the specifications plate and that the cables
section of the electrical plant can bear the load which is also indicated on the plate.
It is recomended that the appliance is connected directly to the mains by fixed wiring, pla
-
cing a double pole switch with minimum opening between the contacts of 3 mm.
Alternative connection methods may be available as long as they conform to current IEE
wiring regulation.
The power supply cable must not touch the hot parts and must be positioned so that it does
not exceed 75°C at any point.
Once the cooker has been installed, the switch must always be accessible.
Before effecting any intervention on the electrical parts the appliance must be di
-
sconnected from the network.
WARNING!
ELECTRICITY CAN BE EXTREMELY DANGEROUS.
THIS APPLIANCE MUST BE EARTHED.
ELECTRICAL FEEDER CABLE CONNECTION
The operations must be executed by a qualified technician.
To connect the supply cable:
•
Remove the screws securing the cover “
A
” on the rear of the cooker (fig. 10.1).
•
Feed the supply cable through the cable clamp “
D
” (fig. 10.1).
The supply cable must be of a suitable size for the current requirements of the applian-
ce; see the section “Feeder cable specifications”.
•
Connect the wires to the terminal block “
B
” as shown in the diagram in figure 10.2; or
connect the phase and neutral wires to the terminal block “
B
” and the earth wire to the
terminal “
PE
” as shown in figure 10.1.
•
Take up any slack in the cable and secure with the cable clamp “
D
”.
•
Replace the cover “
A
”.
N.B. The earth conductor must be left about 3 cm longer than the others.
FEEDER CABLE SPECIFICATIONS
TYPE H05RR-F
230 V ac
3 x 2,5 mm
2
(*)
(*) Connection with wall box connection
ELECTRICAL SECTION
10
Summary of Contents for ENTWIN 90 DF
Page 2: ...2...
Page 20: ...20 S F C T Fig 7 1 Fig 7 2 A B S T Fig 7 3 Fig 7 4 Fig 7 5...
Page 38: ...38...
Page 39: ...39...
