5
SELECT THE STEAM
The quantity of steam is regulated by the steam dial (3).
Move the steam dial to a position between minimum and maximum depending on the
quantity of steam required and the temperature selected.
Warning:
the iron gives off steam continuously only if you hold the iron horizontally. You
can stop the continuous steam by placing the iron in a vertical position or by moving the
steam dial to “0”. As indicated on the temperature control dial (11) and in the initial table,
you can only use steam at the highest temperatures. If the selected temperature is too
low, water may drip onto the plate.
SELECT THE SHORT-STEAM
Press the shot-steam button (5) to generate a powerful burst of steam that can penetrate
the fabrics and smooth the most difficult and tough creases. Wait for a few seconds
before pressing again [Fig. 4].
By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung
garments, etc.) [Fig. 5].
Warning:
the shot-steam function can only be used at high temperatures. Stop the
emission when the indicator light has (9) light up then start ironing again only after the
light has gone off.
SPRAY IRONING
Make sure that there is water in the water tank (10). Press the spray button (4) slowly
(for a dense spray) or quickly (for a vaporized spray) [Fig. 6].
Warning:
for delicate fabrics, we recommend moistening the fabric beforehand using the
spray function (4), or putting a damp cloth between the iron and the fabric. To avoid
staining, do not use the spray on silk or synthetic fabrics.
DRY IRONING
To iron without steam, turn the dry dial (3) to “0” position (no steam).
