26
Fig. 8.1
8 - INSTALLATION
The veneered syntetical
material and the glue used
must be resistant to a temper-
ature of 90°C in order to avoid
ungluing or deformations.
The cooker may be located in
a kitchen, a kitchen/diner or
bed-sitting room but not in a
room containing a bath or
shower.
Curtains must not be fitted
immediatly behind appliance
or within 500 mm of the sides.
It is essential that the cooker
is positioned as stated below.
The cooker must be
installed by a qualified
technician and in
compliance with local
safety standards.
650 mm
500 mm
500 mm
50 mm
afflusso d'aria
Fig. 8.2
air vent
This cookers has class “2/1” overheating protection so that it can be installed next
to a cabinet.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 50 mm must be left between the side of the cooker and the furniture.
The furniture walls adjacent to the cooker must be made of material resistant to heat.
FITTING THE ADJUSTABLE FEET
The adjustable feet must be fitted to the
base of the cooker before use.
Rest the rear of the cooker an a piece
of the polystyrene packaging exposing
the base for the fitting of the feet.
Fit the 4 legs by screwing them tight into
the support base as shown in picture
8.3.
