MonoWave(X) User Manual
ELBY Designs - Laurie Biddulph
9 Follan Close, Kariong, NSW 2250, Australia
9 of 26
The Digital Section
The
MonoWave(X)
has the following digital parameter pages:
The
Information
page (only at power on)
the
Wave Form
page
(this is the default)
the
LFO
page
the
MIDI Channel
selection page
the
Tune/Detune
page
the
Retrigger Options
page
the
Arpeggiator Speed and Mode
selection page
the
Velocity
page
the
Test Mode
page
The various pages are selected by pressing [
F4-
] in combination with one of the other [F..]
keys as listed below:-
[
F1+
] and [
F4-
] = MIDI Channel page
[
F2+
] and [
F4-
] = Tune and Detune page
[
F3+
] and [
F4-
] = Velocity page
[
F4+
] and [
F4-
] = Re-Trigger page
[
F1-
] and [
F4-
] = ARP page
[
F2-
] and [
F4-
] = LFO page
[
F3-
] and [
F4-
] = Test Mode page
In most cases, pressing [F4-] will exit the selected page and return you to the main display
page. In some cases, pressing [F4-
] will take you to a further ‘option’ within the menu. In
all cases, not pressing any key for a few seconds will allow the system to automatically exit
the selected page and return to the main display page.
All parameters are stored in EEPROM and are automatically retrieved each time the
MonoWave(X) is powered on. On exiting from any of these menu pages the system will
display a message indicating that the data has been saved.
Where a number is to be displayed on the screen it may be in either hexadecimal or
decimal depending upon the screen being displayed. In the following documentation any
number that is displayed on the screen in hexadecimal format will be represented in the
text with a preceding 0x. So, for example, when discussing the Wave Banks and Wave
Forms for the two oscillators we use the form 0x12 (decimal 18) whereas in the Test Mode
screen the MIDI Note number is displayed in decimal format such as 12 (0xC).
